CCD Sensor:ICX404AK;ICX405AK
Specification of defect::
| Natural of Defect |
Effective area |
| Inclusion/Bubble/Pit |
40µmMax |
| Dust |
Can be blew away is acceptable |
| Scratch |
10µm Max.In width;
.Invisible after rotated |
| Edge Chips |
Max.0.3mm |
| Memark |
Inspection environment: With class1000 clean room/class100clean booth and 60W bull lamp and around 15cm to objective with normal net eyes. |
Durability test:
1)Any defect shall not be found after 500hours at 85℃;
2)Any defect shall not be found after 500 hours at -20℃,
3)Any defect shall not be found after 100 cycles of test as follows:
【-20℃（30minutes）~+25℃（30 minutes）~+85℃（30 minutes）】as 1 cycle.
Package:
Packing shall be made with a container which is made of a vacuum molded conductive PVC(polyvinyl chloride)and not touch the main surface of optical low pass filter
Application Information
The products of CCD and CMOS photon sensor parts, is used the way of noncontinuity to receive the image, so when screens with some thin line, there will produce some otiose noise. Optical Low Pass Filter (OLPF) is had the function to eliminate this noise. Different thin line direction should use the rightness OLPF to remove. Also for the different model number of CCD, CMOS photon sensor parts have some differences on the specification, for compromise the different model number and the low pass effect, so it need to be used various dissimilarity incise angle (such as 45°, 0°, 90° and WPL), and design a combination of low pass filter which contain “layer, thickness and IR CUT”, then we can clean the noise which bring form screen.
When we use the CCD, CMOS photon sensor parts to screen color scenery, because for color, the response of CCD, CMOS is different from people’s eye, so we should eliminate infrared which photon sensor parts can sense but people’s eye can’t, at the same time adjust its reaction for color in the visible light scope, and to make the color of the image accord with people’s eye’s felling. So we do IR (AR) coating (interference type) on the OLPF’s surface or put the OLPF go with a glass (absorb type) first, then to use them. Because refractive index of quartz is different from air, so it will bring glint on the interface then lower incident light’s strength. In order to lower reflective loss, on the other side of the OLPF do a reflective coating to advance the air’s transmittance, and raise quality of image.
